Finally Ordered

Tire and Wheel Discussion
User avatar
Rich
Senior Member
Posts: 1206
Joined: Thu Sep 20, 2007 9:14
Location: The Conservatory - Aurora, CO
Contact:

Postby Rich » Mon Apr 07, 2008 9:14

Not saying bigger is better. I'm just wondering why he chose the setup. The wheel wells of the MS6 are already gigantic without a set of dropped springs....

bobopud
Posts: 548
Joined: Fri Sep 28, 2007 9:14
Location: The Ranch
Contact:

Postby bobopud » Mon Apr 07, 2008 9:14

Tom is right on all counts.

I went down in size to save weight, better acceleration, better handling, and to have cheaper options for tires.

Also, I think the 18" stock wheels are just too damn big for this car. It is a four door mid size sedan, not a Chrysler 300 family boat. I totally understand why people think that bigger is better, but it just isn't for me.

So, for me, I have a better looking wheel, less weight at the corners, this combo should be about 8 lbs lighter than stock, better acceleration, better handling, and all for much cheaper than I was expecting to pay. Works for me.
2006 SPEED6 Liquid Platinum Sport w/ Nav
Mods Completed - VG Sharkfin, 3M Clear Bra, SU Motor Mount, SU Test Pipe, 35% tint, VEI Digital Boost Gauge, Custom Defrost Vent Pod, PG Exhaust Manifold, CPE Turbo Inlet Pipe, CPE FMIC, Hacked Mazdaspeed CAI into SRI, Synapse BOV, Cobb Accessport EMS Tuner, CPE Dual 3" Catback Exhaust
Mods Needed - Catted Downpipe and finally a tune.

User avatar
jdmsp
Senior Member
Posts: 500
Joined: Thu Sep 20, 2007 9:14
Contact:

Postby jdmsp » Mon Apr 07, 2008 9:14

Nice! I have them in full royal sport bronze.
Image

S4poor

Postby S4poor » Mon Apr 07, 2008 9:14

<div class='quotetop'>QUOTE (bobopud @ Apr 7 2008, 03:50 PM) [url=index.php?act=findpost&pid=38965]<{POST_SNAPBACK}>[/url]</div>
Well, I finally nutted up and ordered new wheels and tires today. They should be here by the end of the week.

I ordered the Rota Torque wheels in 17x7.5 with a 45mm offset. I am slapping on some 225 General Exclaim UHP tires. The Color is Hyper Black. These wheels are 18 lbs each.[/b]


Very nice looking. Wouldn't putting 225's on a 7.5 wheel really stretch them? (Watch the curb when parking) Depends on the aspect ratio too.

coloskydiver
Senior Member
Posts: 845
Joined: Tue Jan 22, 2008 9:14
Location: Aurora, CO
Contact:

Postby coloskydiver » Mon Apr 07, 2008 9:14

Those rims are going to be sick. I think you made a good decision.
[SIGPIC][/SIGPIC]
2005 Nissan Nismo Frontier-Supercharged- SOLD
2006 Speed 6- SOLD
2008 Scion Xd- SOLD
1990 Miata- SuperCharged 331 Fuel Injected Small Block Ford V8-SOLD
2008 Ford F250 Super Duty- Current
2014 Factory Five 818S- In Progress

SpeedRacer
Posts: 5030
Joined: Wed Sep 19, 2007 9:14
Location: Aurora
Contact:

Postby SpeedRacer » Mon Apr 07, 2008 9:14

I think Ron should buy my rims...
Heavy duty adjustable dog leashes
http://www.TitanTuff.com

bobopud
Posts: 548
Joined: Fri Sep 28, 2007 9:14
Location: The Ranch
Contact:

Postby bobopud » Tue Apr 08, 2008 9:14

<div class='quotetop'>QUOTE (RMSpeed6 @ Apr 7 2008, 10:19 PM) [url=index.php?act=findpost&pid=39142]<{POST_SNAPBACK}>[/url]</div>
Very nice looking. Wouldn't putting 225's on a 7.5 wheel really stretch them? (Watch the curb when parking) Depends on the aspect ratio too.[/b]


True, 225s are better suited for an 8" rim since a rim's width should be 90% of the tires width prior to mounting. 225 * .9 ~ 8 inches. 225/7.5 ~ 84% so I am not losing a whole lot. I should only see a difference in handling in extreme cases, like tracking the car. However, the increase in handling of a smaller tire will probably offset the decrease in handling from a wider tire on a smaller rim.

I hope that makes sense. And before anyone doubts my math, 8" is 201.6 mm and 7.5" is 189 mm. So use those numbers in the calcs above.
2006 SPEED6 Liquid Platinum Sport w/ Nav
Mods Completed - VG Sharkfin, 3M Clear Bra, SU Motor Mount, SU Test Pipe, 35% tint, VEI Digital Boost Gauge, Custom Defrost Vent Pod, PG Exhaust Manifold, CPE Turbo Inlet Pipe, CPE FMIC, Hacked Mazdaspeed CAI into SRI, Synapse BOV, Cobb Accessport EMS Tuner, CPE Dual 3" Catback Exhaust
Mods Needed - Catted Downpipe and finally a tune.

MazdaTom
Posts: 2191
Joined: Fri Sep 21, 2007 9:14
Location: Highlands Ranch
Contact:

Postby MazdaTom » Tue Apr 08, 2008 9:14

I have 215 tires on my 7" wide wheel. The sidewalls are vertical. I wouldn't think that a 225 tire on a 7.5" wide wheel would be that bad.

On my old autox/track car I ran a 205 tire on a 6" wide wheel. The sidewalls on those tires would come out. Not ideal, but it worked and LOTS of people did it.
[SIGPIC][/SIGPIC]
1997 Explorer XLT - 4.0 SOHC V6 Controltrac 4x4
mods- 30" BFGs, AAL + TT = 1.5" lift, more to come

S4poor

Postby S4poor » Tue Apr 08, 2008 9:14

<div class='quotetop'>QUOTE (bobopud @ Apr 8 2008, 08:39 AM) [url=index.php?act=findpost&pid=39226]<{POST_SNAPBACK}>[/url]</div>
True, 225s are better suited for an 8" rim since a rim's width should be 90% of the tires width prior to mounting. 225 * .9 ~ 8 inches. 225/7.5 ~ 84% so I am not losing a whole lot. I should only see a difference in handling in extreme cases, like tracking the car. However, the increase in handling of a smaller tire will probably offset the decrease in handling from a wider tire on a smaller rim.

I hope that makes sense. And before anyone doubts my math, 8" is 201.6 mm and 7.5" is 189 mm. So use those numbers in the calcs above.[/b]


Makes complete sense ;-)

MS3_Mafia
Senior Member
Posts: 1533
Joined: Fri Sep 21, 2007 9:14
Location: Lakewood
Contact:

Postby MS3_Mafia » Tue Apr 08, 2008 9:14

We all know you're going with a 225 tire, but what series? 45, 50, 55? Go too small and you're gonna have huge wheel gap.
2007 Mazdaspeed3 Sport</span>
-Mazdaspeed Short Ram Intake
-HKS SSQV Bov
-Tein S-Tech Springs
-225/40/18 Nitto Neo Gen Tires on RX-8 Wheels

<span style="color:#FF0000">http://www.JTuned.com

bobopud
Posts: 548
Joined: Fri Sep 28, 2007 9:14
Location: The Ranch
Contact:

Postby bobopud » Tue Apr 08, 2008 9:14

The tire specs are 225/45/R17. I could care less about the wheel gap, I might go for a .75" drop in the future, but it is pretty low on my list of things to do at this point.
2006 SPEED6 Liquid Platinum Sport w/ Nav
Mods Completed - VG Sharkfin, 3M Clear Bra, SU Motor Mount, SU Test Pipe, 35% tint, VEI Digital Boost Gauge, Custom Defrost Vent Pod, PG Exhaust Manifold, CPE Turbo Inlet Pipe, CPE FMIC, Hacked Mazdaspeed CAI into SRI, Synapse BOV, Cobb Accessport EMS Tuner, CPE Dual 3" Catback Exhaust
Mods Needed - Catted Downpipe and finally a tune.

User avatar
tsx_guy
Senior Member
Posts: 7438
Joined: Wed Sep 19, 2007 9:14
Contact:

Postby tsx_guy » Tue Apr 08, 2008 9:14

<div class='quotetop'>QUOTE (bobopud @ Apr 8 2008, 02:31 PM) [url=index.php?act=findpost&pid=39377]<{POST_SNAPBACK}>[/url]</div>
The tire specs are 225/45/R17. I could care less about the wheel gap, I might go for a .75" drop in the future, but it is pretty low on my list of things to do at this point.[/b]



talk to Brandon about springs...I had a very informative lesson about suspension and have come to love my wheel gap(no joke).... ;)
"20<cut off="">"</cut>

coloskydiver
Senior Member
Posts: 845
Joined: Tue Jan 22, 2008 9:14
Location: Aurora, CO
Contact:

Postby coloskydiver » Tue Apr 08, 2008 9:14

<div class='quotetop'>QUOTE (SpeedRacer @ Apr 7 2008, 10:50 PM) [url=index.php?act=findpost&pid=39155]<{POST_SNAPBACK}>[/url]</div>
I think Ron should buy my rims...[/b]


Whatever. My Enkei's make your rims look like the rims off a 88 Ford Escort. I would even role your rims in Compton. :18756af5:
[SIGPIC][/SIGPIC]
2005 Nissan Nismo Frontier-Supercharged- SOLD
2006 Speed 6- SOLD
2008 Scion Xd- SOLD
1990 Miata- SuperCharged 331 Fuel Injected Small Block Ford V8-SOLD
2008 Ford F250 Super Duty- Current
2014 Factory Five 818S- In Progress

MazdaTom
Posts: 2191
Joined: Fri Sep 21, 2007 9:14
Location: Highlands Ranch
Contact:

Postby MazdaTom » Sat Apr 12, 2008 9:14

Image

Hey Patrick, don't let this happen to your new wheels! ;)
[SIGPIC][/SIGPIC]

1997 Explorer XLT - 4.0 SOHC V6 Controltrac 4x4

mods- 30" BFGs, AAL + TT = 1.5" lift, more to come

User avatar
Robert_K
Posts: 540
Joined: Mon Sep 24, 2007 9:14
Location: Spring, Texas
Contact:

Postby Robert_K » Sat Apr 12, 2008 9:14

Looks good. They remind me of the Work Emotion CR Kai.
Image


Return to “Tires and Wheels”

Who is online

Users browsing this forum: No registered users and 25 guests