1) ETS TMIC, 3.5" - SOLD

2) CP-E Xcel Cold Air Intake - MS6 only. $175 SOLD

3) Custom turbo inlet pipe - aluminum, black, 2.5". Fits MS6/MS3. $100 SOLD

Or #2 and #3 for $225 total!

4) CP-E Standback II w/ PnP harness - Engine management system. MS6 only. $750

5) Redline Tuning QuikLift hood dampers - SOLD

6) Street Unit boost tubes - strong 5-ply silicon tubes that resist flex under boost. MS6 only. $50

7) Street Unit test pipe - 2.5", replaces 2nd catalytic converter, bolts up to factory exhaust. MS6 only. $50

8) AVE Electronics Navigation interface - allows 2 video inputs into stock nav screen, allows for backup camera. MS6/MS3/RX-8 (maybe more). $180

Or everything for $1500.

All items are in good condition, some used but clean, others brand new. Pictures and install help available.

PM or call me at 303-562-6289.

really really good prices

Rich I'll give you $60 for the hood dampers

Hood dampers pending sale.

Bump for everything else!

I'm in the Conservatory too. I think I've seen you a few times. I maybe interested in the TMIC...

So I'm good enough with computers and software, but I know dick about tuning cars.

Do you need to have an intimate knowledge of Non-N/A, internal combustion engines to get some benefit from the Stand-Back?

Batman, give me a call and you can come by to look at it.

Barn, the Standback comes with software that has preloaded settings for stock setups and for bolt-on setups. CP-E released these maps about 6 months ago, and they seem to be working well for people. Eric is running the bolt-on map with his GT28/FMIC/etc. and it works just fine. Because every car is different, you may find that these preset maps aren't exactly dialed in. In that case, taking the car to a dyno shop to have it tuned is the best way to go, unless you have experience in tuning. So potentially, you could spend another 200-300 refining the tune. If you would like to try the SB / PnP on a trial basis, I can help you install it and set it up...then you can run it for a week or two. I've probably had the most experience dealing with the SB on an MS6, so I have no problem helping out.

Hood dampers sold!

Bumpage

Cool Rich. Lemme give it some thought and read-up on it a bit. :thumbsup:

bump.

ETS TMIC pending sale.

Rich wrote:ETS TMIC pending sale.

took long enough, who ever gets this is lucky at that price........

Gmoney wrote:took long enough, who ever gets this is lucky at that price........

Oh I know. I can't friggin' wait!

damn it! I wanted this but it's not a good time for me right now...

ETS TMIC SOLD. Thanks Paul!

CAI/TIP pending sale.