Page 1 of 1
does anyone know how?????
Posted: Fri Jan 16, 2009 9:14
by Syko701
I drive a 2005 6i ATX and I want to paint the inside of my headlight housings. Does anyone know how to and and or baking times to do this??? I know it can be done.
Ha found it!!!!
Posted: Fri Jan 16, 2009 9:14
by Syko701
http://forum.mazda6club.com/index.php?showtopic=10535
enjoy i will take pics while i do this and post them
Posted: Sat Jan 17, 2009 9:14
by bmwzoom
PM Regulator... his name is Eric. He did this on his 2004 6i ATX just a few years ago. Good guy 
Posted: Sat Jan 17, 2009 9:14
by tbot
I know Buffalo did this too, altho he did it to a protege
Posted: Tue Jan 20, 2009 9:14
by memphis
I opened up my 05's to put halo's in.. But I used a heat gun.. was way easier to do that way and was more controlable than to bake it.. Just make sure you dont get any of the sealent on your hands cause its a bitch to get off and wear old clothes you dont care about cause once its on there, its there forever!! have fun!
Posted: Tue Jan 20, 2009 9:14
by Syko701
Good idea... I'll do it
Posted: Tue Jan 20, 2009 9:14
by Syko701
How long did it take you to get the lights out of the 6?