Steps to be taken:
1) Take apart the key from the fob. This is simply done by holding the key perpendicular to the housing.There is a little black spot or "pin" that is holding the key to the "rotational device."
Simply use the screwdriver or toothpick (or what have you) and push this pin out. Be careful not to send it flying because it is easily lost. The key is now free from the device.
2) This step requires the use of a candel and fire. Do this in a controlled environment. I am not to be held responsible if you burn the place that you are attempting this mod at down.
Start off by either lighting the candle or cutting a peice of wax off. Once the candel has meltted a sufficient amount of wax figure out a way to hold the fob uprigth. It's a little tricky if your only using a peice of wax rather than a whole candle.
Now poor some wax into the..."Pit"...where the key goes. Do not fill the pit all the way up or the next step will be a pain. Half way would be sufficient.
3) The third step is to get the key back into the socket. "Well how do you do that smart one?" you ask. Simple....take the key blade and heat the bottom of it up. Don't heat it too long or you'll burn your fingers.
While the blade is hot shove it back into the pit. Wax should spew out the edges but that's ok, we can clean it up later. You have to make sure that you push the key all the way down. Stick the toothpick or screwdriver (or what have you) throught the whole where the black pin goes to clear out any wax. (If you did not get the key all the way down restart from the top of step 3.)
Now that the wax is cleared of the hole replce the little black pin, clean up any excesse wax and enjoy your rattle free key.
