Re: Build thread
Posted: Sun Aug 26, 2018 9:14
Last night I cut the ends of the engine harness terminals for each rotor housing ground and put a connector on there, then made a little harness for the grounds.
2018-08-27_12-12-18 by Eric Jausel, on Flickr
2018-08-27_12-12-33 by Eric Jausel, on Flickr
2018-08-27_12-12-47 by Eric Jausel, on Flickr
I also ground down some excess material off the turbo compressor housing, just where the halves of the cast were joined and any other excess material. I plan to get it polished sometime soon.
Tomorrow we're driving to Broomfield to drop off the suspension hardware at Colorado Cadmium Plating and hopefully I'll get them back soon so I can start getting everything back together.
I was going to get a Ron Davis radiator, but I started wondering if maybe my mounts were causing the radiators to start leaking over time, and considering Ron told me it would be almost $800 and take 4-6 weeks to make, I decided to change the mounts and use a cheaper radiator just in case it ruined it again. So I ordered another Koyo tonight, but this time I ordered a single pass since it's going to be changed to dual pass when it's modified for VMount anyway.
2018-08-27_12-12-18 by Eric Jausel, on Flickr
2018-08-27_12-12-33 by Eric Jausel, on Flickr
2018-08-27_12-12-47 by Eric Jausel, on Flickr
I also ground down some excess material off the turbo compressor housing, just where the halves of the cast were joined and any other excess material. I plan to get it polished sometime soon.
Tomorrow we're driving to Broomfield to drop off the suspension hardware at Colorado Cadmium Plating and hopefully I'll get them back soon so I can start getting everything back together.
I was going to get a Ron Davis radiator, but I started wondering if maybe my mounts were causing the radiators to start leaking over time, and considering Ron told me it would be almost $800 and take 4-6 weeks to make, I decided to change the mounts and use a cheaper radiator just in case it ruined it again. So I ordered another Koyo tonight, but this time I ordered a single pass since it's going to be changed to dual pass when it's modified for VMount anyway.