Page 1 of 2
got tuned today
Posted: Fri Apr 08, 2011 9:14
by Originalguy
made 360whp and 360tq at mac today on the standback without flashes and a 3076r and custom fmic and 3in downpipe to 2.5in catback. kinda proud of the numbers but he said since the standback without flashes cannot outtune the stock throttle mapping i am very limited therefore if i get the flashes OR get an accessport to come back and he claims he can make 400whp. im thinking 380ish but we will see haha. also, anyone have a cobb ap they want to sell for the speed6?
Posted: Fri Apr 08, 2011 9:14
by Operator
Wow, nice numbers!!!
Posted: Fri Apr 08, 2011 9:14
by Originalguy
thanks dude im going for closer to 400 before i graduate at the end of may provided i can get an accessport by then because the flashes would just take too long
Posted: Fri Apr 08, 2011 9:14
by erod550
Yea if you're going to use the Standback you pretty much have to do all their flashes. Nice numbers. I'm assuming those are SAE?
Posted: Sat Apr 09, 2011 9:14
by chickenwafer
Graph?
Posted: Sat Apr 09, 2011 9:14
by Originalguy
i dont have the graphs haha i left those and the stickers at mac because im a dumbass but ill be retuning on the accessport hopefully around this time next month
graphs and vid from that tune will be on here immediately
Posted: Sat Apr 09, 2011 9:14
by reconbygod12
thats pretty solid numbers from that what psi are you at 18 or 19
Posted: Sat Apr 09, 2011 9:14
by Originalguy
im on 17 pounds right now since with the stock ecu throttle map it hit boost cut at anything higher than 18 and we decided to tune it safe for now so we went to 17 until the retune with accessport
Posted: Sat Apr 09, 2011 9:14
by reconbygod12
damn i wish i wouldve went with the 3076 almost though....i was going with one then i decided to go with teh bnr stage 3 and it isnt to bad
Posted: Sat Apr 09, 2011 9:14
by Originalguy
damn thats tight when does that bastard spool?
Posted: Sat Apr 09, 2011 9:14
by reconbygod12
it spools excellence haha...i can hit 400 on that turbo no problem from them my dd is around 375 whp, but the track one i run i think 21.5psi on it..bnr's ive read can handle 27psi, but the ecu on the speeds overboost horrifically aover 23.5 psi, but if you do that with stock internals your lower end of th engine is done, but after i pcs i am rebuilding my motor with cpe forged rods and pistons..pending if i stay in america though
Posted: Sat Apr 09, 2011 9:14
by Originalguy
good call im going for 400 like i said on my DD with the 3076 but then since im off to college at UNC in the next 4 months i'll drive it up there, park it, bike everywhere on campus and use the car to cruise with or go visit denver and such and all the while ill just save up and eventually build it
Posted: Sat Apr 09, 2011 9:14
by chickenwafer
MAC Emails you the graphs (At least they did for me)
This was also full SEA correction, right?
Posted: Sat Apr 09, 2011 9:14
by Originalguy
nope no email from mac and yeah
Posted: Sat Apr 09, 2011 9:14
by erod550
Sometimes Nick forgets to email you the graphs unless you ask him to.